Filter
Top Products
Spin tub frame
17 18
After washing, dismount the water
inlet hose.
Do not store water in the tub for long
p e r i o d . D i s c h a r g e t h e
water immediately after each
using.
Pull of the power plug and hang up
the power cord.
Hang up the drain hose.
Wipe off the water drops on the
surface and inside the tub with clean
soft cloth.
Open the cover of the wash for some
time (about one hour), then
close them.
Wipe the complete unit with soft
cloth twisted dry.
Wipe with neutral detergent if too
dirty.
Do not wash it directly by water.
Do no wipe with thinner, petrol,
alcohol, etc.
Thinner
Alcohol
Petrol
Disposal of the complete unit
1.
2.
3.
4.
5.
6.
7.
8.
9.
-1
-2
-3
-4
-5
-6
-7
-8
-9
10.
-10
If the laundries fall to the out side of the spin tub
If the laundries fal to the outer side of the spin tub, please take them out immediately.
1. Dismantle
As indicated in the figure, push the point marked with to pull the spin tub frame to oblique upwards to
dismantle it.
2. Install
After install the back edge of the spin tub frame to proper position, push the four points marked with "
" by force to reset it.
Please check carefully. The laundries may fall to the lower part of the outer side of the spin tub (as
indicated in the figure.)
If the laundries fall to the outer side of the spin tub, during spinning the draining will get blocked
and the rotation speed of the spin tub is reduced.
Spin tub
Laundries
Using Process
Trouble-shooting (Answers to questions)
Using Process
Disposal after washing
Below 50 C
2-3L
O
Prevent the freezing
(Be sure to discharge the water completely after using)
After complete draining, set the "WASH SELECTOR" at "SOFT" or "STANDARD". If it is set an
"DRAIN", it will be rather difficult for the frozen water to melt.
When the water is frozen
Pour hot water below 50 C into the wash to soak it completely, Then turn the pulsator with hands
gently.
Please confirm the can work normally before next using.
When the remained water is frozen
O