Filter
Top Products
17
Using Process
Trouble-shooting (Answers to questions)
18
Using Process
Trouble-shooting (Answers to questions)
Spin tub frame
If the laundries fall to the out side of the spin tub
If the laundries fal to the outer side of the spin tub, please take them out immediately.
1. Dismantle
As indicated in the figure, push the point marked with to pull the spin tub frame to oblique upwards to
dismantle it.
2. Install
After install the back edge of the spin tub frame to proper position, push the four points marked with "
" by force to reset it.
Please check carefully. The laundries may fall to the lower part of the outer side of the spin tub (as
indicated in the figure.)
If the laundries fall to the outer side of the spin tub, during spinning the draining will get blocked
and the rotation speed of the spin tub is reduced.
Spin tub
Laundries
Below 50 C
2-3L
O
Prevent the freezing
(Be sure to discharge the water completely after using)
After complete draining, set the "WASH SELECTOR" at "SOFT" or "STANDARD". If it is set an
"DRAIN", it will be rather difficult for the frozen water to melt.
When the water is frozen
Pour hot water below 50 C into the wash to soak it completely, Then turn the pulsator with hands
gently.
Please confirm the can work normally before next using.
When the remained water is frozen
O
(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before
sending it to repair. If there are real breakdowns, please com to the special maintenance
department or after-sale service department of our company. Do not repair it by yourself.
Phenomena The reason
The machine does not act.
Is there power failure?
Is the power plug loose?
Is the pulsator twisted by foreign materials?
There's abnormal sound
during washing.
Are there hair pin, coins or metal items brought
inside the tub?
The drainage does not work
Is the drain hose put down?
Is the drain hose frozen?
Is the drain hose blocked by
foreign material?
Are there laundries falling
to the outer side of the spin tub?
Is the machine slanting?
Is the gland pressed evenly?
Are there laundries falling to the outer side
of spin tub?
Are the laundries in spin tub too much?
It is the water remained in the factory inspection
of performance.
There may be some water
flowing out of the drain hose in
the first use of the machine.
There's abnormal sound
and violent vibration during
spinning.