Filter
Top Products
Before Use
8
Installation
Fitting the base cover
Before removing the transportation bolts, please
fix the base cover to the bottom of the washing
machine. Lay down the machine (fig1) screw off
the feet and adjust the base cover with the four
holes corresponding to the screw holes of the
feet. Then screw the feet back on through the
cover and fix it securely to the bottom of the
machine (fig2).
The base keeps out any dampness and reduces
the noise
Removing the transportation bolts
The transportation bolts are designed for clamping,anti-
vibration components inside the washing machine during the
transportation process
Remove the back cover. Fig 1.
Remove the four bolts on the rear side and take out the
synthetic stabilisers from within the machine Fig 2
Replace the back cover. Fig 3.
Fill the holes left by the bolts with blanking plugs. Fig 4.
When replacing the back cover, ensure the convex
surface is facing outwards, and insert the back
cover between the gaps as shown in Fig. 5.
Keep the transportation bolts and synthetic
stabilisers in a safe place for later use
Adjusting the feet
There are adjustable feet under the bottom of the washing machine.
Before use, they should be adjusted so that the machine is level. This will
minimize vibrations and noise during use. It will also reduce wear and tear. We
recommend using a spirit level to level the appliance. The floor should be as
stable and flat as possible.