Filter
Top Products
Technical Data
20
Display Codes
Err7
Err8
Er10
EuAr
End
UNb
Motor Error
Contact the maintenance personnel.
Contact the maintenance personnel.
The signal of Water level sensor is wrong.
Contact the maintenance personnel.
The driving computer and the computer
Contact the maintenance personnel.
board of display can’t communicate.
End of wash cycle.
Washing machine has an unbalanced
unbalanced weight is greater than
allowable maximum, the washing
machine will not spin and will run at
and noise
1. In case washing 1 piece of laundry (carpet,
bed sheet, table sheet, etc.) make it
symmetrical inside the drum.
2.Lower the wet weight of laundry pieces by
wringing manually and placing them back
of the drum.
4. Add 1 or 2 pieces of laundry into the
drum to reduce the unbalanced load
effects.
5. Restart the spin cycle by closing spin
programme. In case the failure persists,
please ask a qualified technician to repair it.
When the above error code displays, we suggest switch off the power and restart the
machine to operate again, If error still exists, please contact the maintenance personnel.