Filter
Top Products
"Power" button
Push the "power" button to switch on the power.
Under power-on mode, push it to switch off the power.
Push the "power" button to switch on the power. If the
"start/pause" button is not pushed, the machine will
switch off the power automatically after 5 minutes.
Reserve,Process,remain time digitron
It displays "--" during detecting.
It displays remained reserve time (hour).
It displays total remained time (min). If the total time
exceeds 99 minutes, it uses "A" on tens digit to
represent100 minutes, and uses "b" to represent 110
minutes.E.g. "A3" represents 103 minutes.
It displays abnormal symbol in abnormal situation.
(See to Page15)
WATER LEVEL button
Attention As selecting the water level 1,3,5,7,9;the light
is Flashing;
As selecting the water level 2,4,6,8,10;the light
is lighting;
The washing machine can detect the laundries automatically.
After detection,it will set the water level to suitable value among
4, 6, 8,and 10 automatically.
You can also set water level by yourself. After the machine is
started, it will not set water level automatically. You shall push the
"start/pause" button to make new setting.
If there's water inside the tub, the machine cannot detect the
laundries and will display water level 6 .
If save program is selected, it will display water level 2 .
When water level 2 is reached in water filling, it will perform
washing while filling water.When water level 3 is reached, it will
change to normal washing.
During operation of wash and rinse program, you can push down
the
"water level" button to add water. When you release the button, or
it reaches the overflow water level, the machine will stop adding
water.
The water level decided may be different from actual value because
of the different moisture level of the laundries.
PROGRAM/RESERVE button
Push down the "program/ reserve" button. You
can select one program of ten which is
standard,soak heavy, gentle,save,cotton,
single wash,rinse spin,single spin,tub clean,
air dry;
Push the"program/ reserve" button to set the
reserve wash program morethan two seconds
continuously;
When the "reserve" function is activated, the
indicator light of the program you have set
will be off. The "reserve (hour)" and "time
remain" indicator lights will be on;
During reserve procedure, push the "reserve"
button to display the reserve mode.To change
the running program or cancel the reserve
setting, you need to switch off the power
and make new selection;
PROGRAM/RESERVE
WATER
LEVEL
POWER
ON/OFF
LIG
HT
FL
AS
H
TIME REMAINED(M INUTES)
RESERVE(HOURS LATER)
Digital display
Digital display
Fuzzy logic control
Fuzzy logic control
10 water level selection
10 water level selection
Digital display
Digital display
Fuzzy logic control
Fuzzy logic control
10 water level selection
10 water level selection
Digital display
Digital display
Fuzzy logic control
Fuzzy logic control
10 water level selection
10 water level selection
Digital display
Digital display
Fuzzy logic control
Fuzzy logic control
10 water level selection
10 water level selection