Filter
Top Products
11
Use the operation buttons
Off
On: indicate the program about to run,or indicate
the selected mode or indicate the water level
Flashing: indicate the running program
During sensing, it displays “--” .
During delay procedure, it displays the
remained delay time (in hours).
During operation of programs,it displays the
remaining time (in minutes).
In case of abnormal phenomenon, it displays
the abnormal symbols (see to Page 15 ).
After the power is switched on,press it to start
the machine.
During working, push it to pause.
During pause, push this button to restart
and go on working .
Push the “Power” button to
switch on the power.
When the power is on, push it again to
switch off the power.
Push the “Power” button to
switch on the power.If the “
Start/Pause
”
button is not pushed, the washing machine
will automatically switch off the power
after 5 minutes.
The digitron displays the time remained (in minutes)
before the washing is finished.
Push the “Delay” button, the digitron displaysthe delay
time of washing (in hours).The indicator flashes to
indicate that the delay function is operating.
Push the “Delay” button to display the delay mode.
Standard
Wool
Tub Dry
Memory
Strong
Normal
Soft
Quick
Remaining
Time
Delay Time
18L
26L
34L
43L
30L
38L
47L
52L
22L
14L
3rd Rinse
2nd Rinse
1st Rinse
Water
Water
level
Power
Program
Start/Pause
Program Applicable situation
Normal
Strong
Soft
Washing the normal laundries
Washing the bigger and heavier laundries
Washing the woollen textiles or underwear
Quick
Memory
Standard
Wool
Washing the laundries with small quantity
and light soil
Tub Dry
Drying the inner tub and the outer tub,
which can avoid growing mildew
Washing the woollen textiles
The common wash, the washer will set to
Custom program including wash, rinse,
spin and water level automatically last time
The washing machine can detect the laundries
automatically after detection, it will set the water
level to suitable value among level 26L,34L,43L,
52L automatically during the Normal,Memory
and Standard program.
You can also set water level by yourself.After the
machine is started, it will not set water level
automatically. You shall push the “Start/Pause”
button to make new setting.
If there’s water inside the tub, the machine can
not detect the laundries and will display water
level 34L .If wet laundries are put in, it may
display water level 52L.You must set suitable
water level by yourself.
If Quick program is selected, it will display
water
level 22L, the water level can be adjusted.
If Tub Dry program is selected, the water level
will not respond.
During operation of wash , rinse and soak
program, you can push down the water level
button to add water. When you release the
button, or it reaches the overflow water level,
the machine will stop adding water.
The water level decided may be different from
actual value because of the different moisture
level of the laundries.
Washing the normal laundries with less water
During Memory,Strong,Soft,Normal and Standard
program you can adjust the value of them.
For Wool you can select procedure , but can not
change them.
Overflow
Reserve
SpinRinse Delay
Wash
You can choose “Reserve Water” to keep water.
It will keep the after rinsing water once finish rinsing
in tub about 4 hours ,and buzzer every 15 minutes .
Press “Start/Pause” button or open and close the top
one time to collect the after rinsing water ,or else it
will drain automatically,then go on for next program .