Filter
Top Products
12
b Steps of using the operation buttons and description of each step.
Page 11
WASH
SOAK
RINSE
SPIN
FLASH
LIGHT
FLASH
LIGHT
STANDARD
COMMON
FUZZY
POSTHASTE
QUICK
JEANS
FIBRE
COTTON
TUB DRY
START/PAUSE
PROCESS/FUNCTION
RESERVE
WATER LEVEL
PROGRAM
POWER
HEAVY WASH
HEAVY RINSE
HEAVY SPIN
GENTLE SPIN
Push the "POWER ON/OFF " button to switch on the power.
Push the "PROGRAM" button to select the suitable
automatic program.
POWER
PROGRAM
After switching on the power, the machine will set common program automatically.Toselect other
automatic program, push the "program" button till the relative indicator is light or flash. Refer to the
"program button" on Page 11 for the selection. For instance: select "Posthaste"program for laundries
with small quantity and light soil.
In selecting the common and standard program, the machine will execute fuzzy program
to select water level and wash time according to the cloth and weight of the laundries.
The full procedure is controlled automatically.
Push the "PROCESS/FUNCTION"button to select suitable procedure and function.
Attention
Even there's no water in the tub, a certain period is required before spin starting.
Wash and spin after putting the damageable clothes into tuck net, to avoid scathe.
The pulsator will rotate brokenly when the water level reach to 4.
Do not use the soak program for the woolen textiles
The soak procedure can work in cooperation with automatic programs like common, cotton, standard, jeans, fibre. There
is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during soak washing, and can not
make setting in other cases.
When running the saving water program, if the water pressure is too lower, the machine will adjust program from saving to sluicing
automatically for the effect of rinsing.
RESERVE HOURS
SURPLUS MINUTES
It has the special power resume function. In the case of powerfailure
or the power plug is loose during washing, the machine can save
the running program, and resume the program after the power
supply is recovered. You do not need to set the program again.