Filter
Top Products
8
The drain hose shall drain smoothly.
Do not trample or press the drain hose.2The height of the drain hose shall be less
than 10cm , or the drainage will not be smooth,
and cost such long time that the machine may
stop at mid way.
1
3
5
4
If the drain hose is too long, cut it at mid
point. To make smooth drainage,cut the front
end of the hose slantingly.
If the extra hose is too long,cut it either at A or at B point.
If extra drain hose is needed,please
make separate purchase.The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
How to change the direction of the drain hose
Figure 2
Figure 3
Back cover
Figure 1
Up claws
Screws
Figure 4
Down claws
Two sides claws
Drain hose rack
Screws
1. Dismount the back cover of the
washing machine.
2. Put down the drain hose. Take off
the drain hose rack. Then take off the
screws of the drain hose rack.
Put the drain hose into the cabinet.
(As indicated in Figure 2).
3. Extend the drain hose from the
other side. And then fix the screws of
the drain hose rack. And f ix the drain
hose onto the cabinet with the drain
hose rack. (As indicated in Figure 3).
4. Install the back cover, first put the
down claws on the cabinet, and then
put the claws(marked with )into the
cabinet from down to up, and fix the
screws. (As indicated in Figure 4)