Filter
Top Products
11
Use the operation buttons
Off
On: indicate the program about to run,or indicate
the selected mode or indicate the water level
Flashing: indicate the running program
During sensing, it displays “--” .
During delay procedure, it displays the
remained delay time (in hours).
During operation of programs,it displays the
remaining time (in minutes).
In case of abnormal phenomenon, it displays
the abnormal symbols (see to Page 15).
Program Applicable situation
STANDARD
HEAVY
Washing the normal laundries
Washing the bigger and heavier laundries
GENTLE Washing the woollen textiles or underwear
QUICK
Washing the laundries with small quantity
and light soil
Washing the blanket
Washing the cotton textiles
Washing the woollen textiles
BLANKET
COTTON
WOOL
TUB DRY
Drying the inner tub and the outer tub,
which can avoid growing mildew
After the power is switched on,press it to start
the machine.
During working, push it to pause.
During pause, push this button to restart
and go on working
Push the “POWER ON/OFF” button to
switch on the power.
When the power is on, push it again to
switch off the power.
Push the “POWER ON/OFF” button to
switch on the power.If the “START/PAUSE”
button is not pushed, the washing machine
will automatically switch off the power
after 5 minutes.
The digitron displays the time remained
(in minutes) before the washing is fi nished.
Push the “DELAY” button, the digitron
displaysthe delay time of washing (in hours).
The indicator flashes to indicate that the
delay function is operating.
Push the “DELAY” button to display the
delay mode.
During the standard program,the washing
machine can detect the laundries automatically.
After detection,it will set the water level to
suitable value automatically among the water
level “LOW”,”MEDIUM”,“HIGH” and ”MAXIMUM”.
You can also set water level by yourself.After the
machine is started, it will not set water level
automatically. You shall push the “START/PAUSE”
button to make new setting.
If there’s water inside the tub, the machine can
not detect the laundries and will display water
level “MEDIUM” .If wet laundries are put in, it
may display water level “MAXIMUM”.You must
set suitable water level by yourself.
If QUICK program is selected, it will display water
level “LOW”,the water level can not be adjusted.
If TUB DRY program is selected, the water level
will not respond.
During operation of wash , rinse and soak
program, you can push down the water level
button to add water. When you release the
button, or it reaches the overfl ow water level,
the machine will stop adding water.
The water level decided may be different from
actual value because of the different moisture
level of the laundries.
Power
Start/Pause
Soft
Tub Dry
Soak
Standard
Rinse
Wash
Quick
Spin
Water level
Program
Delay
46L
37L
29L
18L
41L
33L
24L
12L
Flash
Normally on
On/Off
REMAIN(MINUTES)
RESERVE(HOURS)