Filter
Top Products
5
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important
to your security and correct operating the machine.
1. move the control handle of trundle to
the point 1 and the control handle fix on
the second reference column; then insert
the base panel from the side and fix it in
the suitable site which aim to the hool of bolt.
2.Caste hit the control handle position
shown in the figure ,the control will be
fixed by the frist reference columns to
install the screw into the bottom of the
washing machine with a screwdriver,
then gently propped.
the control handle of trundle
Adjust the adjustable foot:
To twist the adjustable foot, please fi rst lift up the side of the leg slightly, loosen the
adjustable nut, and twist the foot. Please make sure to keep the washing machine
in balance.
1.
After adjustment, fasten the nut.
The adjustable foot
2.
The washing machine away from wall should be overrun 20mm. The largest allowable slope
of the shank base of the machine is 2°. The slanting or rough ground will result in unstable
running or stoppage of the machine. Please adjust it with following methods:
CarpetCarpet
Back
Front
the adjustable foot
Bottom plate
Screw
Confirm
it's horizontal:
Hang the lead line to check if it is horizontal.
the frist reference colunm
pullback spring
figure 1 figure 2
the operation of trundle
the second
reference colunm