Filter
Top Products
6
Connecting the hose to the cold
water supply
1. Connect the nut on the water
inlet hose to the connector on
the water valve. Ensure all seals
are in place.
2. Tighten the nut to secure the
hose.
Drain hose
• The height of the drainage outlet must
be between 80-100cm. To prevent the
drain hose from dropping, attach it
using the drain hose clip at the back of
the washing machine.
• Use the hose clip to secure the end
of the drain hose and to prevent the
outflow of water. It is recommended
that the length of the drain hose is not extended by way of a hose extension.
In case of absolute need, we recommend that the extension has the same
diameter as the existing hose and does not exceed 250cm in length.
Note: The drain hose should not be underwater and should be securely fixed
and leak-free. When the drain hose is placed on the ground or the height
of the pipe is less than 80cm, the washing machine will continuously drain
while being filled (self-syphoning).
Connection to the power supply
Before connecting to the power supply, make sure that:
• The socket is suitable or the maximum power of the washing machine (for
safety, fuses in the power circuit should be rated for no less than 13A).
• The supply voltage should be within the values indicated on the
specifications page.
• The power supply socket and the plug of the washing machine should
be compatible. If they are not compatible, refer to a washing machine
technician or Haier designated service engineer for power cable replacement.
• The washing machine should be earthed and in compliance with applicable
law.
• Additional earthing cables should not be necessary if the socket and plug are
earthed.
• If required, an additional earthing cable should be installed on the upper
back of the washing machine and earthed.
Installation
Water inlet hose nut
Water inlet valve connector