Filter
Top Products
18
M
AINTENAN
CE
CODES CAUSES SOLUTIONS
Err1 ¬ Washer door is not properly shut. _ Close the washer door properly
Err2 ¬ Drainage error. _ Clean the fi lter and check the drain hose for block-
age.
Err3 ¬ Temperature sensor error
(Appears at the end of a cycle).
_ Please contact the Service Center.
Err4 ¬ Heater error (Appears at the end of a cycle). _ Please contact the Service Center
Err5 ¬ Water inlet error. _ Check the tap and the water pressure.
Err6 ¬ Motor error. _ Please contact the Service Center.
Err7 ¬ Motor error. _ Please contact the Service Center.
Err8 ¬ Water exceeds protective level. _ Please contact the Service Center.
unb ¬ Laundry is unevenly distributed. _ Redistribute laundry to balance the drum.
End ¬ End of wash cycle.
1:16 ¬ Remaining time is 1 hour and 16 minutes.
0:01 ¬ Remaining time is 1 minute.
60 ¬ Preset washing temperature is 60° C.
-- ¬ Cold wash.
800 ¬ Preset spinning speed is 800rpm.
DISPLAY CODES
DISPLAY CODES AND SPECIAL FUNCTIONS
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a
program. It can no longer be changed by operating buttons or knobs. The washing machine emits an audible signal while the control
panel is locked. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the pres-
ent settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program or select a new program and options during the wash cycles.
a) Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
b) If you wish to select an option during the wash cycle, press the "Start/Pause" button, then select the desired option and press the
"Start/Pause" button again.
Note: 1.The Rinse hold function can be selected directly without pressing fi rst the "Start/Pause" button, but before the machine starts
the spin program.
2.Alarm sound can be cancelled if it is needed. Please follow the instruction as below:
Switch on the washing machine and turn the program knob to spin cycle, then press the delay button and hold on for 3 seconds. The
“b OFF” will be displayed on the screen which indicates that alarm sound has been canceled. To operate the above steps again so the
alarm sound can be recovered and the display will show “b ON”
3.CLRF:Too much foam used in wash cycle.Washing machine can eliminate the foam automatically during spin cycle.If the washing
machine fails to eliminate the excessive foam, it will end the cycle without spinning.