Filter
Top Products
18
Water inlet valve and inlet valve filter
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve filter regularly.
Moving the machine
If the machine is to be moved to a distant locaƟon, replace the transportaƟon bolts removed before
installaƟon to prevent damage as shown below.
Remove the back cover.
Remove the blanking plugs.
Insert the syntheƟc stabilizers and the transportaƟon bolts.
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse
If the washing machine is leŌ idle for a long period, pull out the electrical plug and turn off the water
supply. Open the washer door to prevent formaƟon of moisture and odors. Let the door open while
not used.
Display Codes
Display Codes and Special funcons
Codes Causes SoluƟons
Err1 Door is not properly shut. Shut the door properly, and then press the
Start/Pause buƩon.
Err2 Drainage error, water not empƟed within
6 minutes.
Clean the filter and check the drain hose
for blockage. If error sƟll exists, please
contact the maintenance personnel.
Err3 Temperature sensor not properly
connected or damaged.
Contact the maintenance personnel.
Err4 Heater error (Appears at the end of a
cycle).
Contact the maintenance personnel.
Err5 Water level not met in 8 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
Make sure that tap is turned on, and water
pressure is normal.
If problem sƟll exists, please contact the
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
Maintenance