Filter
Top Products
9
Extra Rinse
Start/Pause
Buon
Press this buƩon, the washing machine will perform addiƟonal rinses.Press
the buƩon once to select one addiƟonal rinse. The display will show"P-1".
Press the buƩon repeatedly and the screen will display "P-2''or "P-3'',
indicaƟng two or three addiƟonal selected rinses. The "extra rinse light" is
acƟvated and flashes during the performance. "P-1/2/3" is displayed
alternaƟng with the remaining Ɵme. The light turns off and the display
disappears when the extra rinse ends.
When the washing machine is connected to the power socket and a
program is selected, lightly touch this buƩon to start operaƟon. During
a wash cycle, touch it lightly ,operaƟon will stop and the digits on the
screen start blinking. Touch it again to resume operaƟon. To cancel a wash
program during a wash cycle, touch this buƩon, when the digits on the
screen start blinking, press the Power switch, the program will be cancelled.
Before a washing program,select this program to set the washing load
(1/2Full),the washing machine will automaƟcally adjust the water
consumpƟon and washing Ɵme.
InformaƟon as remaining wash Ɵme and error messages will be shown here.
Touch this buƩon lightly, the washing machine will start operaƟon aŌer a
period of Ɵme and the corresponding indicator will go on. The range is 0.5-24
hours; each touch of this buƩon increases a half hour. AŌer the buƩon is set,
press the Start/Pause buƩon to start countdown of the set Ɵme (the Ɵme is
displayed on the screen unƟl the program ends).
AŌer a wash program is started the display will go on and the
remaining wash Ɵme decreases. As the water pressure and
temperature may differ, the remaining Ɵme may be adjusted
accordingly. When the laundry is not balanced during spinning, the
Ɵme may be automaƟcally prolonged.
Select this funcƟon when programe 1-9 is selected.
The delay Ɵme must be longer than the program Ɵme otherwise
the washing machine will start the wash program directly.
To cancel audible alarm
Alarm sound can be cancelled if it is required (not recommended)
Switch on the washing machine and turn the program knob to spin cycle, then press the
"Delay" and "Extra rinse" buƩon, hold on for 3 seconds.
The message "BEEP OFF” will be displayed on the screen, indicaƟng that the alarm sound has
been cancelled.
To reinstate audible alarm
Switch on the washing machine and turn the program knob to spin cycle, then press the
"Delay" and "Extra rinse" buƩon, hold on for 3 seconds.The "BEEP ON" message will be
displayed on the screen, indicaƟng that the alarm sound has been reinstated.
Funcons
7
8
ECO
9
LED Display
10
Delay
11