Filter
Top Products
3. Do not place heavy, heating source or wet articles
on the top of the washing machine.
4. Do not hot wash foam rubber or sponge-like
materials.
6. Do not open the detergent distribution d rawer
during the wash cycle..
7. The door is fitted with a self-lock device and will not
open until 2~3 minutes after the washing machine
stops. Do not force the door open. Do not open the
door if water level can reach the porthole.
8. After each wash program, turn off t he tap to prevent
leakage; and unplug the washing machine and
wipe clean the lower part of the porthole.
Steel wires in bras will pop
out during washing; never
wash bras containing steel
wires.
5. Before washing, do up zippers, buttons and clothes
straps and put small articles, such as socks, laces
or bras, into a washing bag or a pillow .
Matters Needing Attention
Troubleshooting
The following circumstances do not constitute problems. Do not contact the maintenance service
until the problem has been confirmed.
Problem Possible cause
The washing machine f ail s to operate
Poor connection to power supply
Power failure
Door is not properly closed (It will show E1)
Machine has not been switched on
Washing m achine cannot b e filled
with water
Water tap is not turned on(It will show E4)
Water pressure is less than 0.03Mpa
The inlet hose is kinked
Water supply failure
The program dial is not properly set
The door is not properly closed
The inlet hose filter is blocked
The machine is draining while is
being filled
The height of the drainage hose is below 80cm (it
should be within 80-100cm)
The d rainage hose end is in water
Drainage failure
Drainage hose is blocked (It will show E2)
Drainage hose end is exceed 100cm above the floor
level
The filter is blocked
Strong vibration during spin drying
Not all packing bolts have been removed
Washing machine is located on an uneven surface
Machine load is over 5kg.
Operation stops before completion
of a wash cycle
Water or electricity failure
Washing machine is in soak cycle
Operation stops for a period of time
Washing machine is in soak cycle
Washing machine gives an error message.
Excessive foam in the drum, which
is spilled to the distribution drawer
The detergent is not a low-foaming type or for manual
wash
Excessive use of detergent
9.Keep the door slightly open when the washing machine is not in use to prevent formation of doors;
do not cover the washing machine with plastic cover so that inside dampness cannot be
kept in.