Filter
Top Products
PROBLEM POSSIBLE CAUSE AND REMEDY
WATERWON’T
● Make sure drain hose is not kinked.
DRAIN
● Top of drain outlet should be less than 8 ft. above floor.
WATERLEAKS
● Make sure hose connections are tight at faucets.
● Make sure end of drain hose is correctly inserted in and secured to drain facility.
WASHER IS NOISY
● Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
● A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in? This sound is normal.
● Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the lid and redistribute the load evenly about the wash basket. Close
the lid and restart.
WASHER PAUSES
● Washer normally pauses between washing steps. . .such as between wash and spin or
IN CYCLE between spin and rinse.
1
If you need more help... call, toll free:
The GE Answer Center@
●
800.62ii2000
consumer information service
25