Filter
Top Products
4
Installation Instructions
CONNECTING TO GAS SUPPLY
Connect the gas supply to the dryer. If codes
allow, use new flexible metal tubing (design
certified by the American Gas Association).
Be sure there are no kinks. For gas connections,
you MUST use pipe-joint compound resistant
to the action of LP gas.
CAUTION: Be sure electricity is OFF at
power supply source (circuit breaker/fuse box).
Plug power cord into electrical outlet.
IMPORTANT:
120-volt, 60 hz, AC-only electrical supply
is required on a separate 15-ampere circuit fused by
a time-delay fuse or circuit breaker.
14
14A
NOTE: Do not, under
any circumstances,
remove grounding
prong from plug.
Grounding
prong
FINAL APPLIANCE LEVELING
CAUTION: ALL WEIGHT MUST BE
REMOVED FROM APPLIANCE LEVELING LEG WHILE
ADJUSTING. THREADS ON LEG WILL BE DAMAGED
OTHERWISE.
Again, make sure the appliance rests firmly on
all four legs. No rocking of the appliance should
occur.
15
CHECKING APPLIANCE OPERATION
Make sure all packing and shipping materials
are removed, including the washer shipping bolt
and plastic spacer block.
Route drain hose properly—not coiled
or kinked.
Make sure water inlet hoses are connected
(HOT to HOT) and tightened securely without
kinks. Turn on water faucets and check for leaks.
Tape all joints to make sure exhaust ductwork
is secured without leaks.
Turn on electricity at the power source.
Turn on the washer and dryer and run through
one cycle. Check all hoses for leaks. Ensure
the burner has lit.
NOTE:
Before the burner will light, it is necessary for
the gas line to be bled of air. If the burner does not light
within 45 seconds the first time the dryer is turned on,
the safety switch will shut off the burner. If this happens,
turn the timer to “OFF” and wait 5 minutes before
making another attempt to light.
17D
17C
17B
17A
17
16
REPLACING FRONT ACCESS PANEL
Reinstall the safety cover and front access panel.
Place the Owner’s Manual and Installation
Instructions in a location where they can be
found by the customer.
19
18