Filter
Top Products
HOW TO
OPEMTE
YOUR WASHER
Features and appearances may vary slightly
WARNINGTO reduce the risk of fire, electric shock, or injury to persons when using your
appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
..:”AT*
,,,8,,.6,
~emake,b””dw
.:
:&:
ramp
Load Stze
Stafi
e
o
@@
See How to Operate Your
Dyer
sect;on
for the above Dryer controls
Setting the Controls
Use the Suggested Fabric and Cycle Settings guide
to help you make the proper selections.
~
Select
Water Level.
SMALL: Washer is less than 1/3 full of clothes.
MEDIUM: Between 1/3 and 2/3 full.
LARGE: Over 2/3 full.
For best cleaning results, the load must be able to move
freely in the water. Too
big
a load or too little water can
cause wear or tear of load items.
~
Select
Was~inse
Temperature.
~
Wsh
Cycle Selector knob
inandturn
clockwise to
your selected wash setting.
@
Wll
Cycle
Selector knob
*START
out to start the washer.
If
you wish to
change
setting
after washer has started, push
-1
-.
Cycle Selector knob into stop
STOP
~
the washer and reset to the new
position. Setting can be changed at any time.
Washer Lid Latch
To Add Items After Washer Has
Stirted
For easier loading convenience,
use the washer lid latch.
To hold the washer lid
up, lift the lid
until
it
snaps past the latch
under the control panel.
To release the lid, push
the lid latch up.
@
● Turn off the washer.
● Latch the washer lid.
● Add any additional articles by submerging them next
to the agitator.
NOTE: When washing stockings, panty hose and
other easily tangled items, always handle separately.
To minimize tangling, we recommend the use of a net
LID MTCH
laundry bag.
How to Soak in Your Washer
Allow
the washer to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob to stop the washer
(keep
lid
closed) and allow to soak for as long as desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
6