Filter
Top Products
9. Remove the large Styrofoam block located under the
drum. Lift up on the drum, tilt the base of the foam
block inwards toward the rear of the washer until free,
and then pull the block out.
10. Remove and discard the yellow ribbon and label from
the front of the washer.
11. From the rear of the washer, carefully pull out the
power supply cord through the hole in the backsheet.
12. Replace the service panel and screws.
Save all bolts, washers, spacers, brackets, clamps, and
blocks for future use.
NOTE: If you must transport the washer at a later date,
you must reinstall the shipping support hardware to
prevent shipping damage. Keep the hardware in the
plastic bag provided.
13
Installation Instructions
UNPACKING THE WASHER
WARNING: Destroy the carton and plastic
bags after the washer is unpacked. Children might use
them for play. Cartons covered with rugs, bedspreads,
or plastic sheets can become airtight chambers
causing suffocation. Place all materials in a garbage
container or make materials inaccessible to children.
1. Cut the shipping carton along the dotted line at the
base of the unit.
2. While it is in the carton, carefully lay the washer on its
back side.
3. Remove the styrofoam base.
4. Carefully return the washer to an upright position and
remove the carton.
5. Carefully move the washer to within 4 feet (122 cm) of
the final location.
6. Remove the following from the back side of the washer:
4 bolts
4 yellow plastic spacers
3 metal “P” clamps
7. Remove the service panel from the front of the washer.
8. Remove the 4 nuts and 6 large washers that attach the
2 yellow shipping braces to the drum and the base.
Lift up on the drum and remove the braces (a yellow
ribbon surrounds the items to be removed). These
braces must be removed to allow the power supply
cord to be released from the shipping ring.
NOTE: Failure to remove the shipping braces can cause
the washer to become severely unbalanced.
6
11
BOLT
SPACER
"P" CLAMP
10
8
9
12
7
8