Filter
Top Products
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1.In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2.In an area where it will come in contact with curtains
or drapes.
3.On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2″ per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0″ (0 cm)
• When installed in closet: Sides, Rear,
Top = 0″ (0 cm), Front = 1″ (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
2
), located 3″
(7.6 cm) from top and bottom of door
Undercounter Installation
If an undercounter* installation is desired, you MUST
install a top sheet kit, 14-A037. This kit is available through
your GE retailer.
*Custom-sized countertop is required.
Mobile Home Installation
Installation must conform to Standard for Mobile Homes,
ANSI A119.1 and National Mobile Home Construction
and Safety Standards Act of 1974 (PL93-383).
Installation Instructions
12
TOOLS REQUIRED FOR
WASHER INSTALLATION
• 1/4″ nut driver
• 3/8″ socket with ratchet
• 3/8″ open-end wrench
• 7/16″ socket with ratchet
• 9/16″ open-end wrench
• Channel-lock adjustable pliers
• Carpenter’s level