Filter
Top Products
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
6
About washer features.
Cleaning the Fabric Softener Dispenser 32731)13()07
The Fabric Softener Dispenser is self cleaning. This dispenser does not require regular cleaning
like standard fabric softener dispensers. Wipe down exterior surfaces of the dispenser
as needed. If cleaning of the internal dispenser components is needed, follow these steps
after the wash cycle is complete:
The Fabric Softener Dispenser 32731)13()07
Lift the tab on the fabric softener
dispenser top.
Measure out fabric softener into
the cap and pour the softener into
the dispenser top. The fabric softener
will drain into the receiving cup inside
the dispenser. Use only “Ultra” or
concentrated fabric softeners.
Push down on the tab to close
the dispenser top. Make sure the tab
is pushed down fully and snaps shut.
Select FABRIC SOFTENER from SETTINGS
on the control panel.
NOTE: Overfilling the dispenser will cause
fabric softener to drain out of the holes in the
side of the infusor when filling. Do not overfill.
4
3
2
1
OPTIONS
FABRIC SOFTENER
With
2nd RINSE
OFF
EXT.
SPIN
2nd
RINSE
The fabric softener dispenser %9831%8-'%00=6)0)%7)70-59-(*%&6-'73*8)2)6%88,)4634)68-1)
(96-2+8,)'='0)
Do not stop the washer or raise the lid during the first spin. This will cause the dispenser to
empty
too soon.
Never pour fabric softener directly on clothes. This may cause stains on your clothing.
397)*3003;8,)7)78)47
Lift the dispenser top tab and turn the top
counterclockwise using the 2 turning tabs
shown. Lift the dispenser out of the
Infusor™.
Clean out any buildup from inside the
Infusor™ with a soft cloth or toothbrush.
Ensure the three rectangular holes
in the bottom which allow the fabric
softener to drain are not blocked.
Gently pull the cap away from
the dispenser cup to separate.
Wipe surfaces with a soft cloth or soak
the parts in a solution of 1 gallon warm
water, 1/4 cup liquid detergent and 1 cup
bleach. Ensure the small hole in the top
surface of the cap and associated tube
are not obstructed.
Reassemble the dispenser cup and cap
by snapping them together.
Place the dispenser assembly into
the Infusor™. Turn the top clockwise
using the 2 turning tabs shown. Push
down on the tab to close the dispenser
top. Make sure the tab is pushed down
fully and snaps shut.
2
6
5
4
3
1
1
2
3
4
Tab
Turning Tabs
Turning Tabs
1
3
5
6