Filter
Top Products
Installation Instructions
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Prompt registration confirms your right to protection under the
terms of your warranty.
www.GEAppliances.com
For Questions on Installation, Call: 1-800-626-2000 (US) or
1-800-561-3344 (Canada).
ADDING COVER PLATE TO REAR
OF CABINET
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider.
Place dryer in final location.
PLATE
(KIT WE1M454)
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
13 CHANGING DIRECTION OF
DOOR OPENING
14 SERVICING
REMOVE 4
HINGE SCREWS.
ROTATE DOOR 180
AND REINSTALL.
REMOVE 4 HOLE PLUGS AND
PLACE THEM IN THE HOLES
ON THE OPPOSITE SIDE.
WARNING - LABEL ALL WIRES
PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INST ALLATION.
WARNING - NEVER LEAVE THE
BACK OPENING WITHOUT THE PLATE.
For replacement parts and other information, refer to
Owner's Manual for servicing phone numbers.
8
0
• Insert the elbow through the rear opening and connect
it to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
Pub. #31-15476
500A436P006
Pub. # 31-16225
PLATE
(KIT WE1M454)