Filter
Top Products
13
General installation
Grounding type
Grounding type
wa
wa
ll receptacl
ll receptacle
Po
Po
wer cord with
wer cord with
3-prong
3-prong
gr
gr
ounded plug
ounded plug
Do not,
Do not,
under
under
an
an
y cir
y cir
cumstances,
cumstances,
cut,
cut,
remo
remo
ve
ve,
or b
or b
ypass th
ypass the
gr
gr
ounding pr
ounding pr
ong.
ong.
Connect the exhaust duct to the outside exhaust system 1.
(see pages 4 through 6). Use of a 4” (10.2 cm) clamp (item
A) is recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other joints.
Carefully slide the dryer to its fi nal position. Adjust one or 2.
more of the legs until the dryer is resting solidly on all four
legs. Place a level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and discard door
tape.
Plug the power cord into a grounded outlet.3.
Turn on the power at the circuit breaker/fuse box.4.
Read the5. Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
If you have any questions during initial operation, please 6.
review the “Avoid Service Checklist” in your Use & Care
Guide before calling for service.
Place these instructions in a location near the dryer for 7.
future reference.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
A wiring diagram and technical data sheet are
located inside the dryer console.
A