Filter
Top Products
The dryer is equipped with a three-prong (grounding) plug 1.
for your protection against shock hazard and should be
plugged directly into a properly grounded three-prong
receptacle.
The plug must be plugged into an appropriate outlet that 2.
is properly installed and grounded in accordance with all
local codes and ordinances. If in doubt, call a licensed
electrician.
DO NOT cut or remove ground prong from the plug.
Grounding type
Grounding type
wa
wa
ll receptacl
ll receptacle
Po
Po
wer cord with
wer cord with
3-prong
3-prong
gr
gr
ounded plug
ounded plug
Do not,
Do not,
under
under
an
an
y cir
y cir
cumstances,
cumstances,
cut,
cut,
remo
remo
ve
ve,
or b
or b
ypass th
ypass the
gr
gr
ounding pr
ounding pr
ong.
ong.
Grounding requirements - Gas dryer (USA and Canada)
Gas connection
Remove the shipping cap from gas pipe at the rear of the 1.
dryer.
Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved 2.
pipe from gas supply line to the 3/8 inch (0.96 cm) pipe
located on the back of the dryer. Use a 1/2 inch to 3/8
inch (1.27 cm to 0.96 cm) reducer for the connection.
Apply an approved thread sealer that is resistant to the
corrosive action of liquefi ed gases on all pipe connections.
Open the shutoff valve in the gas supply line to allow gas 3.
to fl ow through the pipe. Wait a few minutes for gas to
move through the gas line.
All connections must be wrench-tightened
Flare
Union
Flare
Union
GAS FLOW
Manual
Shuto
Valve
Closed
Open
Flexible
Connector
Inlet Pipe on
Back of Dryer
elppiN
Shuto Valve -
Open position
to dryer
from gas supply
Check for gas system leaks with a manometer. If a 4.
manometer is not available, test all connections by
brushing on a soapy water solution.
10
- EXPLOSION HAZARD - NEVER test for gas
leaks with an open fl ame.
The supply line must be equipped with an ap-
proved manual shutoff valve. This valve should be located in
the same room as the dryer and should be in a location that
allows ease of opening and closing. Do not block access to
the gas shutoff valve.
DO NOT connect the dryer to L.P. gas service
without converting the gas valve. An L.P. conversion kit must
be installed by a qualifi ed gas technician.