Filter
Top Products
Using the automatic cycles
(on some models)
Your automatic control senses the dryness of
the load and automatically shuts off when the
selected dryness is reached. For the first few
loads:
1. Set the Cycle Control Knob to point to the
center dot in your automatic cycle.
2. Select a heat setting to match your load.
3. Push the Start Button. The Cycle Control
Knob will not move until the load is almost
dry or the cool-down portion of the cycle has
been reached. After the cool down, the
Cycle Control Knob automatically moves to
an OFF area and the tumbling stops.
Feel the dried items when the dryer stops:
If the Items are drier than you like, select a
setting closer to LESS DRY the next time you
dry a similar load.
If items are not as dry as you like, select a
setting closer to VERY DRY the next time you
dry a similar load.
Using the Air cycle (no heat)
The dryer does not heat when the Cycle Control
Knob is set in the Air cycle. This cycle can be
used to fluff or air dry bedding, plastic table-
cloths, foam pillows, sneakers, etc.
1. Turn the Cycle Control Knob to the number of
minutes you want in the Air cycle. (If your
dryer has Temperature Selector, no tempera-
ture needs to be selected. Cycle is unheated.)
Refer to the chart below for suggested times.
2. Push the Start Button.
NOTE: Repeat steps above if more time is
needed to dry items.
TYPE OF LOAD
I
AIR CYCLE
I
RUBBER, PLASTIC, HEAT-SENSITIVE FABRICS
I
Foam Rubber-Pillows, bras, stuffed toys
Plastic-Shower curtains, tablecloths
Rubber-backed rugs
Olefin, Polypropylene, Sheer nylon
20-30 min
20-30 min
40-50 min
15-20 min
8