Filter
Top Products
25
5. Set the machine upright and remove the remaining
rear screw. Slide out the relevant pin.
6. Plug all the holes with the plugs which you will
find in the envolope containing the instruction
manual.
Important !
You are advised to keep all the packaging for re-use
in case the machine is to be transported again.
In case of moving out the same precautions as per
paragraphe “The dangers of freezing” must be
taken i.e. the residual water in the hoses must be
pumped out.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Never place cardboard, wood or similar materials
under the machine to compensate for any
unevenness in the floor.
Your new washing machine has been designed to be
permanently plumbed in to your home’s water supply
and drainage system. However, if this is not possible,
it may be connected to suitable existing tap with the
drain hose discharging into a sink.
The appliance has one inlet hose, with female 3/4”
BSP thread connector. If this connection is not
compatible with the plumbing of the existing
installation, a variety of connectors are available from
good hardware stores and plumbers merchants to
suit most domestic plumbing. Any alteration to your
existing plumbing must be carried out by a
competent person, or qualified plumber.
Installation on a Suspended Floor
Suspended wooden floors are particularly
susceptible to vibration. To help prevent vibration we
recommend you place a waterproof wood panel, at
least 15 mm thick under the appliance, secured to at
least 2 floor beams with screws. If possible install the
appliance in one of the corners of the room, where
the floor is more stable.
P0002
P1128
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transported
again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by placing
one of the corner packing pieces between the
machine and the floor
2. Remove the polystyrene block(s) from the bottom
of the machine and release the two plastic bags.
3. Very carefully slide out the left polythene bag,
removing it towards the right and then
downwards.
4. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.
Remove the bottom cover found inside the drum
of your appliance, lay it’s hook as the arrow ’A’
indicates and push the top of the cover to seal it
closed
Important: You can find more detailed instructions
regarding the bottom cover assembling in it’s relative
bag.
P1129
P0001
P1123
2
3
1
P1126
P1127
New_12108_14108.qxp 12/12/2005 5:41 PM Page 25