Filter
Top Products
22
Changing bulb for interior light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the local Service Force Centre.
1 Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1 Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully remove the fuse.
1.Unscrew the lampcover (this can be found directly behind the loading
aperture, at the top; refer to “Description of machine” section.)
2.Replace defective bulb.
3.Replace the lampcover.
1 Warning! For reasons associated with safety, the lampcover must be
screwed down tightly. If this is not done, the dryer must not be operat-
ed.
Drying cycle ends
shortly after pro-
gramme starts. END
display illuminated.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete“).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
SPECIAL CARE button
pressed and load volume too
big.
SPECIAL CARE is only suitable
for use with loads of up to
3kg!
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Problem Possible cause Remedy