Filter
Top Products
30
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is leaking out
from under the
washing machine.
The screw connection on the
inlet hose is leaking.
Screw the inlet hose in
firmly.
The drainage hose is leaking. Replace drain hose.
The drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Softener was not
washed in. w
compartment for
conditioners is filled
with water.
The conditioner insert is not
correctly set into the
additive compartment or is
blocked.
Clean the detergent
dispenser drawer, insert the
conditioner insert firmly.
Washing is heavily
creased.
There may have been too
much washing in the
machine.
Observe maximum loads.
The door cannot be
opened when the
appliance is switched
on. The
v
symbol
appears in the display.
The door is locked for safety
reasons.
Wait until the O symbol
appears.
The display goes out
while a wash cycle is
running.
Power cut.
For safety reasons, the door
will remain locked for
approx. 4 minutes.
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the
appliance, before opening
the door, first perform an
emergency drain.
The background
illumination of the
display has gone out
even though the
appliance is switched
on.
The washing machine is in
stand-by mode.
Press any key.
Problem Possible cause Remedy