Filter
Top Products
19
The END indicator is
flashing 1x.
(Problems with the wa-
ter inflow.)
The tap is turned off. Turn on the tap.
The filter in the inlet hose
screw connection is blocked.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
The tap is blocked by limes-
cale or is faulty.
Check the tap and have it re-
paired, if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed.
Removing the transit pack-
aging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
The inlet hose screw con-
nection is leaking.
Tighten the inlet hose.
The outlet hose is leaking. Replace outlet hose.
The drain pump lid has not
been closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
The emergency drain hose is
leaking.
Screw on the emergency
drain hose firmly.
There is a lot of foam.
Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
The END indicator is
flashing 2x.
(Problems with the wa-
ter outflow.)
There is a kink in the outlet
hose.
Straighten the hose.
The maximum pump height
of 1m has been exceeded.
Please contact your local
Service Force Centre
The drain pump is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
the spigot is blocked.
Clean the spigot.
Problem Possible cause Remedy