Filter
Top Products
11
Running a wash cycle
Opening the door/loading washing
1.Open the door: pull the handle on the door.
When the appliance is switched on, the DOOR and START/PAUSE indica-
tors show whether the door can be opened:
2.Separate washing and load loosely.
Mix large and small items.
Important: Do not get any washing
caught between the door and the
rubber seal.
3.Firmly push the door shut. Door
catch must audibly click shut.
Adding detergent/conditioner
Important! Only use detergents/conditioners that are suitable for use
in domestic washing machines.
Add detergent/conditioner in accordance with the detergent/condi-
tioner manufacturer’s instructions. Observe instructions on the packag-
ing.
The amount of detergent used depends on:
– the washing’s degree of soiling,
– the load size
– the hardness of the tap water.
• If the manufacturer does not make any recommendations with re-
gard to small volumes of washing: for a half-load use a third less, and
for a very small load use only half the amount of detergent that is
recommended for a full load.
• Water softener should be used from water hardness range 2 (=medi-
um). The amount of detergent used can then always be that as for
hardness range 1 (=soft). Your local water company will provide you
with information about water hardness in your area.
DOOR indicator START/PAUSE indicator Can the door be opened?
flashing flashing yes, after approx. 2 minutes
illuminated illuminated
no, water level and/or
temperature too high
is off flashing yes