Filter
Top Products
Operating Instructions
35
The washing machine
vibrates when operat-
ing or is noisy.
The transit packaging has not
been removed.
Remove the transit packag-
ing as described in the In-
stallation and Connection
instructions.
The machine is not level.
Adjust the feet according to
the Installation and Connec-
tion instructions.
There is very little washing in
the drum (for example, one
dressing gown).
This does not affect the op-
eration of the machine.
Water could not be fully
drained out before spinning,
because the
drain hose is kinked or the
water pump is blocked.
Check the drain hose and re-
move any kink if necessary or
clean the water pump and if
necessary remove foreign
bodies from the pump hous-
ing.
Excessive foaming dur-
ing the main wash.
Probably too much detergent
has been used.
It may be necessary to re-
duce the amount of deter-
gent used. Follow the
manufacturer's recommen-
dations.
Water leaks out of the
washing machine.
The screw connection on the
inlet hose is leaking.
Tighten the inlet hose screw
connection.
The drainage hose is leaking.
Check the drainage hose and
replace if necessary.
The drain pump cover is not
correctly closed.
Close the cover correctly.
Washing is caught in the
door.
Stop the programme and re-
move the washing caught in
the door. Restart the pro-
gramme.
The emergency emptying
hose is not correctly closed
or is leaking.
Close the emergency empty-
ing hose (see Section “Carry
out emergency emptying”).
Call your local Service Force
Centre, if the emergency
emptying hose is leaking.
Problem Possible Cause Remedy