Filter
Top Products
to construct the base should have a
non slip surface, be water repellent and
if possible be one solid piece.
If it is not possible to use one solid
piece, due to the additional height
required, ensure that any additional
strips of timber are glued and screwed
to the underside of the base (see Fig.
F).
Drill four fixing holes see Fig. G.
Position the base into the recess with
its front edge as far forward as the
adjoining plinth line will allow.
The reason for placing the base in
this position is to allow a small
strip of beading to be fitted in front
of the appliance feet.
Fix the base firmly to the floor using
four appropriate countersunk screws
(see Fig. H).
With the appliance installed adjust all
four feet ensuring the machine is sta-
ble, and a clearance of approximately 5
600-605
5 X 25 X 605
Hardwood strip
5 mm x 25 mm
H
490
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G
mm is left between the top of the
machine and the underside of the
worktop.
A final check for stability should be car-
ried out with the machine on spin with
a load, this will identify the need for any
further fine adjustment to the feet.
A strip of beading approximately 605
mm W, x 5 mm H, x 25 mm D must be
screwed down into the base directly in
front of the machine’s feet, this will pro-
vide additional security.
If required an additional door magnet,
part number 1242394-00/3 and disc,
part number 1242393-00/5 are avail-
able from spare parts.
44 electrolux installation
132962470.qxd 11/08/2008 11.20 Page 44