Electrolux EWX 14450 W Washer/Dryer User Manual


 
Altering an option or a running
programme
It is possible to change some options
before the programme carries it out.
Before you make any change, you must
pause the washer-dryer by pressing
button
8.
(Only the Time Manager option cannot
be modified after the programme has
started. )
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to O and then
to the new programme position. Start
the new programme by pressing button
8 again. The washing water in the tub
will not be emptied out.
Interrupting a programme
Press button
8 to interrupt a
programme which is running, the
corresponding light starts to flash. Press
the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to O to cancel a
programme which is running. You can
now select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing button
8.
If the light
9 blinks and then goes off,
the door can be opened.
If the light
9 remains lit, this means
that the machine is already heating,
that the water level is too high.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to O. After a few minutes the door can
be opened (pay attention to the
water level and temperature!).
After closing the door, it is necessary to
select the programme and options
again and press button
8.
At the end of the programme
The machine stops automatically, the
pilot light of button
8 goes off and
three blinking «0.00» will appear on the
display. The buzzer sounds.
If a programme with an option that
ends with water still in the tub has
been selected, the pilot light
9 remains
lit and the door is locked to indicate
that the water must be emptied out
before opening the door.
To empty out the water:
turn the programme selector dial to
O
select the Drain or the Spin
programme
reduce the spin speed if needed, by
pressing the relevant button
press button 8
At the end of programme, the display
shows 3 flashing zeros «0.00». the pilot
lights 9 goes off and the door can be
opened.
Turn the programme selector dial to O
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
16 electrolux use
132962470.qxd 11/08/2008 11.20 Page 16