Filter
Top Products
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8.
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to O to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
USE - DRYING
DRYING ONLY
Warning!
The recommended load size is 3.5 kg for
cottons and linen, 2 kg for synthetic items
and 1.5 kg for wool.
Important! For wool items the timed drying
is the only drying available (Drying Time
button).
By pressing Drying Time button it is
also possible to dry up to 5 kg of cot-
ton items (see the «Drying Pro-
gramme » table).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of laun-
dry in order to obtain the best drying
performances.
3. Select the drying programme for Cot-
tons, Synthetic or Wool in the Drying
sector of the programme selector dial.
4. If you wish to select an automatic dry-
ing (for cottons and synthetic items on-
ly), press the button 4 until the light cor-
responding to the required dryness de-
gree illuminates.
5. If you wish to select a timed drying,
press the button 5 until the time you
want appears on the display (see the
«Drying Programme» table). Every time
you press this button the drying time in-
creases by 5 minutes.
Note!
The programme time will automatically
increase by some minutes.
6. Press button 8 to start the programme.
The time remaining is updated every
minute.
7. At the end of the programme, the buz-
zer sounds. Three blinking «0.00» zeros
appear on the display.
During the last 10 minutes of the drying
cycle the appliance performs an anti-
crease phase. Through this time the
door is locked. The display shows three
flashing zeros «0.00».
If you wish to open the door before or
during the anti-crease phase or to in-
terrupt it, press any button or turn the
programme selector dial to any pro-
gramme position (except O).
8. Turn the selector dial to the O position
to switch the machine off.
9. Remove the laundry from the drum.
Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase
may result in partial dryness. In the excep-
tional case that at the end of the cycle the
laundry remains slightly wet, we suggest
that you unfold the rolled up items, redis-
tribute them evenly in the drum and select
an additional drying cycle of 20-30 minutes.
Important!
12 electrolux