Filter
Top Products
SELECT THE TIME MANAGER OPTION
BY PRESSING BUTTONS 10
By pressing these buttons repeatedly, the
duration of the washing cycle can be in-
creased or decreased. The soil level icon
will appear on the display to indicate the
chosen degree of soil. This option is availa-
ble only with Cotton, Synthetic and Deli-
cate programmes.
Soil Level Icon Type of fabric
Intensive For heavy soiled
items
Normal For normal soiled
items
Daily For daily soiled
items
Light For slightly soiled
items
Quick For very slightly
soiled items
Super Quick
1)
For items used or
worn for a short
time
Refresh
1)
2)
For refreshing items
only
Super Re-
fresh
1)
2)
For refreshing a very
few items only
1) We recommend you to reduce the load sizes (see
Washing programmes table).
2) When you select this option the relevant icon appears
just for a while and then it disappears immediately.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 8 (if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection
again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started and
through the delay time the door is locked. If
for any reason, you need to open it, set
firstly the machine to PAUSE by pressing
the button 8.
After a few minutes it will be possible to
open the door.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8.
AT THE END OF THE PROGRAMME
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some
acoustic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the
water must be emptied out before opening
the door.
Before you empty out the water, the drum
continues to run at regular intervals until the
water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning pro-
gramme.
electrolux 11