Filter
Top Products
22 electrolux starting an iron aidtm programme
Iron Aid programme complete /
removing laundry
After the Iron Aid phase has ended, 0.00
is illuminated and the message
ANTICREASE appears in the display.
If the BUZZER (ALARMA) has been
activated, an audible signal sounds at
regular intervals.
The Iron Aid programme is automat-
ically followed by an anti-crease
phase, including brief steam phas-
es, which lasts around 90 minutes.
The drum rotates during the anti-crease
phase. This keeps the laundry loose and
free of creases. It can be removed at any
point during the anti-crease phase, ex-
cept during steam phases (look for
steam animation in the display!). Laun-
dry should be removed as quickly as
possible.
1. Open the loading door to remove the
laundry.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See “Cleaning and maintenance”
section.)
3. Remove laundry one garment at a
time.
To retain the effects of the Iron Aid
treatment, clothes must be removed
one garment at a time during the
anti-crease phase and hung imme-
diately on a clothes hanger to dry
(for at least 5-15 mins, depending on
fabric and selected steam level). Do
up the buttons and tug the garment
into shape, paying particular atten-
tion to cuffs and seams.
4. Turn the programme knob to O OFF.
Important! After each drying cycle
– Clean the micro-fine filter and fine fil-
ter
– Drain the condensed water contain-
er
(See section “Cleaning and mainte-
nance”.)
5. Close door.