Filter
Top Products
20
Starting a programme
1.Check that the water tap is open.
2.Press the START/PAUSE key.
The programme is started or it starts after the time delay set has
elapsed.
3 If after pressing the START/PAUSE key the display shows “Door not
Closed”, the door has not been shut properly. Push the door firmly
closed and press the START/PAUSE key again.
Programme progress
The display indicates the
stage of the programme that
is currently being performed
as well as the time to the
end of the programme.
3 During the wash cycle the
time to the end of the pro-
gramme may change as the
programme adjusts itself to different conditions (e. g., type and quanti-
ty of laundry, out of balance spin detection, special rinses, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
• The programme can be interrupted at any time by pressing
the START/PAUSE key. It is then re-started by pressing the key again.
• To stop the washing machine before the programme has ended, turn
the programme knob to OFF.
Attention! Be careful if there is water in the appliance!
Adding washing
1.Press the START/PAUSE key.
• If “Door locked” and “Pause” are alternately shown in the display, it is
no longer possible to add washing, e. g. when the water level is too
high.
• If “Door openable” and “Pause” are alternately shown in the display, it
is still possible to add washing:
2.Open the door.
3.Add washing and close the door again.
4.Press the START/PAUSE key again. The programme continues.
LINEN/EASY CARE
12.45
Washing
14.37
50C 800 aýýýýýaýaýaýaýaýaýaýaýa
TEMP. RPM OPTIONS OK TIME