Filter
Top Products
Operating Instructions
35
When the additional rinse function is selected, the RINSE
+
indicator on
the program progress display illuminates prior to program start and
during the additional rinse.
4.
If you wish to check whether the additional rinse function is selected:
Turn the program selector to SHORT SPIN.
Press the SOAKING button briefly.
If RINSE
+
flashes on the program progress display, the additional rinse
function is set.
Disabling the Additional Rinse Function:
0
1.
Turn the program selector to SHORT SPIN.
2.
Press the SOAKING button for at least 5 seconds.
As soon as the button is pressed RINSE
+
flashes on the program
progress display. After 5 seconds RINSE
+
ceases to flash and illumi-
nates continuously for a further 5 seconds.
3.
Whilst RINSE
+
is continuously illuminated, release the SOAKING
button.
Once RINSE
+
has ceased to illuminate, the additional rinse function is
disabled.
Wash-Water Cooling
3
The water is cooled prior to pumping out at the end of the main wash
(by adding cold water). This setting is only effective for COTTON/LINEN
at a temperature of over 40° C.)
Wash-water cooling is not selected upon delivery from the factory.
Select Wash-Water Cooling:
0
1.
Turn the program selector to SHORT SPIN.
2.
Press the PRE WASH button for at least 5 seconds.
After the button has been kept pressed for 5 seconds, MAINWASH
flashes on the program progress display for 5 seconds.
3.
Whilst MAINWASH is flashing, release the PRE WASH button.
After blinking has stopped, wash-water cooling is selected. It remains
functional until it is deleted.
4.
If you want to check and see if wash-water cooling has been selected:
Turn the program selector to SHORT SPIN.
Press the PRE WASH button briefly.
If MAINWASH flashes on the program progress display, the wash-water
cooling function is set.