Filter
Top Products
Operating Instructions
24
End of Wash Cycle/Removing the Washing
Once the washing program has come to an end, END illuminates on the
program progress display.
If RINSE HOLD was selected, the indicator beside the START/PAUSE but-
ton flashes.
0
1.
After a rinse hold, the water has to be pumped out:
Press either the START/PAUSE button (the washing will be spun in
accordance with the program that has just been completed; the spin
speed can also be changed during spinning using the SPIN button),
or
turn the program selector to PUMP OUT, and press the START/PAUSE
button (the water is pumped out without spinning),
or
turn the program selector to SPIN or SHORT SPIN, and press the
START/PAUSE button (the washing will be spun or short spun).
At the end of this program step, the END indicator illuminates.
2.
Open door.
As soon as the indicator beside the DOOR/LIGHT button is green, the
door can be opened (not when the child safety device is activated,
please refer to "Child safety device").
3.
Remove the washing.
4.
Set program selector to OFF.
5.
Pull the detergent dispenser drawer out a little after washing so that it
can dry out. Leave the door ajar for a while. This helps to prevent stag-
nant smells and helps to preserve the door seal.
3
If the OVERDOSING indicator illuminates, then too much detergent was
used in the washing program just completed, and as a result an addi-
tional rinse performed. For the next wash observe the detergent manu-
facturers dosing instructions appropriate to the load!
Important!
If the washing machine is not used for a lengthy period of time:
Close the tap and disconnect the washing machine from the mains.
(Aqua control with aqua alarm does not function if the washing
machine has been disconnected from the power supply.)