Filter
Top Products
19
Reversing Door
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3 Protect fl at work surface, such as top of dryer or fl oor near dryer,
with a soft cloth or towel.
4 Be sure dryer is unplugged from power source!
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
Preparing to reverse door swing
Screwdrivers with
#2 square &
straight bit
Tools needed:
A) Removing Trim Ring
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
course-thread, panhead screw.
3 Close door.
4 Rotate door trim approximately ¾” counter-
clockwise and pull ring away from door.
4 Gently place door face down on fl at, covered
work surface.
3 While supporting the weight of the door
with both hands, separate the door from the
hinge.
B) Removing Door from Hinge
1 Reopen door to 90 degree angle.
2 Remove 4 long, course-thread, counter-sunk
hinge screws from door.
Removing door and hardware