Filter
Top Products
6 / EN
Washing Machine / User’s Manual
1. Connect the special hoses supplied with the machine to
the water inlets on the machine . Red hose (left) (max. 90
ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is
for cold water inlet.
A
WARNING: Ensure that the cold and hot water
connections are made correctly when installing the
machine to prevent laundry from coming out hot after
the washing process resulting in undue wear.
2. Tighten all hose nuts by hand. Never use a tool when
tightening the nuts.
3. Open the taps fully after completing the hose connection
and check for water leaks. If there are any leaks, turn off
the tap and remove the nut. Retighten the nut carefully
after checking the seal. To prevent water leakages and
damages caused by them, keep the taps closed when the
machine is not in use.
2.5 Connecting to the drain
• The end of the drain hose must be directly connected to
the wastewater drain or to the washbasin.
A
WARNING: Ensure that the end of the discharge hose
is securely fixed into its housing to ensure the smooth
flow of water and to avoid any risk of flooding and injury
from hot water.
• The hose must be attached to a height of at least 40 cm,
and 100 cm at the most.
• In case the hose is elevated after laying it on the floor
level or close to the ground (less than 40 cm above the
ground), water discharge becomes more difficult and
the laundry may come out excessively wet. Therefore,
follow the heights described in the figure. Ensure that the
heights in the figure are followed.
100cm
40cm
• To prevent flowing of dirty water back into the machine
and to allow for easy discharge, do not immerse the hose
end into the dirty water or do not drive it in the drain more
than 15 cm. If it is too long, cut it short.
• The end of the hose must not be bent, it must not be
stepped on and the hose must not be pinched between
the drain and the machine.
• If the length of the hose is too short, use it by adding
an original extension hose. Length of the hose may
not be longer than 3.2 m. To avoid water leak failures,
the connection between the extension hose and the
drain hose of the machine must be fitted well with an
appropriate clamp as not to come off and leak.
2.6 Adjusting the feet
A
WARNING: In order to ensure that the machine
operates more silently and vibration-free, it must stand
level and balanced on its feet. Balance the machine
by adjusting the feet. Otherwise, the machine may
move from its place and cause crushing and vibration
problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the machine stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
WARNING: Do not use any tools to loosen the lock
nuts. Otherwise, they will get damaged.
2.7 Electrical connection
Connect the machine to a grounded outlet protected by
a 16 A fuse. The manufacturer and seller do not accept
responsibility for any damage due to incorrect electrical
connection.
• Connection must comply with national regulations.
• The Power cable plug must be within easy reach after
installation.
• If the current value of the fuse or breaker in the house is
less than 16 Amps, have a qualified electrician install a
16 Amp fuse.
• The voltage specified in the "Technical specifications"
section must be equal to your mains voltage.
• Do not make connections via extension cables or multi-
plugs.
B
WARNING: Damaged power cables must be
replaced by an Authorized Service Agents.