Filter
Top Products
5 / EN
Washing Machine / User’s Manual
2 Installation
Refer to the nearest Authorised Service Agent for installation
of the machine . To make the machine ready for use, review
the information in the user manual and make sure that the
electricity, tap water supply and water drainage systems are
appropriate before calling the Authorized Service Agent. If
they are not, call a qualified technician and plumber to have
any necessary arrangements carried out.
C
Preparation of location, electrical, tap water and waste
water installations of the machine are the customer's
responsibility.
Ensure that the water inlet and discharge hoses as well
as the power cable are not folded, pinched or crushed,
during or after installation or cleaning procedures.
B
Warning: Installation and electrical connections of the
machine must be carried out by an Authorized Service
Agent. The Manufacturer shall not be held liable for
damages that may arise.
A
Warning: Prior to installation, visually check if the
machine has any defects on it. If so, do not have it
installed. A damaged machine is a safety risk.
2.1 Appropriate installation location
• Place the machine on a rigid floor that has sufficient load
carrying capacit. Do not place it on a long pile rug or
similar surfaces.
• Total weight of the washing machine and the dryer -with
full load- when they are placed on top of each other
reaches to approx. 180 kilograms. Place the machine
on a solid and flat floor that has sufficient load carrying
capacity!
• Do not place the machine on the power cable.
• Do not install the machine at places where temperature
may fall below 0ºC.
• Place the machine at least 1 cm away from the edges of
other furniture.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon. Do not perform this operation alone.
2.3 Removing the transportation locks
A
WARNING: Do not remove the transportation locks
before taking out the packaging reinforcement.
WARNING: Remove the transportation safety bolts
before operating the washing machine! Otherwise, the
machine will be damaged.
1. Loosen all the bolts with a suitable spanner until they
rotate freely
(C).
2. Remove transportation safety bolts by turning them
gently.
3. Attach the plastic covers supplied in the User Manual bag
into the holes on the rear panel.
(P)
C
Keep the transportation safety bolts in a safe place to
reuse when the washing machine needs to be moved
again in the future.
Never move the machine without the transportation
safety bolts properly fixed in place!
2.4 Connecting water supply
C
The water supply pressure required to run the machine
is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to
have 10 – 80 liters of water flowing from the fully open
tap in one minute to have your machine run smoothly.
Attach a pressure reducing valve if water pressure is
higher.
If only the single (cold) water-inlet is going to be used,
the blind stopper must be installed to the hot water valve
before operating the machine. (Only applies to machines
supplied with a blind stopper).
A
WARNING: Models with a single water inlet must not
be connected to the hot water tap. In such a case the
laundry will get damaged or the machine will switch to
protection mode and will not operate.
WARNING: Do not use old or used water inlet hoses
on the new machine . It may cause stains on your
laundry.