Filter
Top Products
Page 8
Operation
ADDING DETERGENT
• Add a measured amount of detergent to the detergent
drawer. Use only detergent specifically recommended
for top loading washers and follow the manufacturer’s
instructions.
• If required, add a measure of liquid chlorine bleach to
the bleach inlet. Avoid spilling bleach onto the clothes in
the machine as undiluted bleach may damage them.
• If desired add measured liquid fabric softener to the
softener inlet until it reaches the load line. Avoid spilling
undiluted softener onto the clothes in the tub as it may
damage them.
OPERATING THE MACHINE
• Press the POWER ON pad.
• Select the desired wash cycle ( any of the pre-
programmed washes or any customised programme).
• Press the START / HOLD pad.
• The machine will automatically dispense detergent,
bleach and softener at the appropriate time during the
wash, rinse and spin cycle and then stop.
• Open the lid, remove the laundry and switch off.
• Close the taps.
HOT
OPTIONAL
COLD
BEFORE ANY OF THE WASH OPTIONS ARE SELECTED YOU MUST FIRST:
• Insert the power plug into an earthed wall socket and switch on.
• Open the hot and cold water taps.
• Load the washing into the machine.( see Loading)
• Add detergent and if necessary softener and bleach.( See Adding detergents below)
•
Close the lid.
• NOTE: DO NOT OPEN THE HOT WATER TAP WITHOUT OPENING THE COLD WATER TAP ALSO.
• IT IS ESSENTIAL TO OPEN THE COLD WATER TAP FOR ALL PROGRAMMES
.