Filter
Top Products
Page 7
Installation and electrical connections of the
machine must be carried out by an
Authorized Service Agent. Review
information in the user manual and ensure
that the electricity, water supply and water
drainage systems are appropriate before
calling an Authorized Service Agent. If they
are not, call a qualified technician and
plumber to have any necessary
arrangements carried out.
4 Installation
Appropriate installation location
• Place the machine on a rigid floor that has
sufficient load carrying capacity.
• Choose a well ventilated dry location out
of direct sunlight.
• Do not place the machine on the power
cable.
• Do not install the machine at places where
the temperature may fall below 0ºC.
• Place the machine at least 10 mm away
from the edges of other furniture.
• Hot and cold water taps should be located
within 1 metre of the inlet valves.
Adjust the adjustable leg of the machine if
necessary to ensure that the machine is
level. The maximum permissible inclination
of the ground surface is 2 degrees. A
machine that is not levelled and is unstable
will vibrate and generate excessive noise.
Connecting the water supply
1. Check that the sealing washers are
correctly seated.
2. Attach the curved end of the water supply
hose to the inlet valve of the machine,
tighten the coupling nuts by hand. Never
use a tool when tightening the nuts.
3. Attach the straight end of the hose to the
tap. Tighten the coupling nuts by hand.
4. Open the taps fully after completing the
hose connection and check for water
leaks. If there are any leaks, turn off the
tap and remove the nut. Retighten the nut
carefully after checking the seal. To
prevent water leakages and damages
caused by them, keep the taps closed
when the machine is not in use.
Preparation of location, electrical, tap
water and waste water installations of
the machine are the customer's
responsibility.
Warning: Installation and electrical
connections of the machine must be
carried out by an Authorized Service
Agent. The Manufacturer shall not be
held liable for damages that may arise.
Warning: Prior to installation, visually
check if the machine has any defects
on it. If so, do not have it installed. A
damaged machine is a safety risk.
Ensure that the water inlet, discharge
hoses and power cable are not folded,
pinched or crushed, during or after
installation or cleaning procedures.
Installing the bottom cover
1. Unplug the power cord of the machine.
2. Carefully lay the front side of the machine
on a soft mat or cushion. (Be careful not
to dent the frame)
3. Slide the bottom cover into the retainers
and push the cover all the way in.
4. Fasten the bottom cover with the supplied
screw.
5. Carefully move the machine back into the
upright position.
Warning: Do not place the machine
on a rug or carpeted floor as this may
restrict ventilation openings at the
bottom of the machine.
Warning: Do not use old or used water
inlet hoses on the new machine It may
cause stains on your laundry.