Filter
Top Products
Page 14
TWO STEP
The water inlet is controlled in 2 steps:
The first step (1) is with a lesser amount of
water, thus the density of the detergent is
higher than normal. After washing for a
period of time, the second step is activated
(2) and the machine allows the rest of the
water in.
For example, the water level was set at 5,
the machine may give level 2, for step (1),
then the rest of the water level 3, for step (2).
• This function will not be activated when
selecting water level 1 or 2, and the
DELICATE or BLANKET function.
• When SOAK is selected, this function will
not be activated after soaking.
CHILD LOCK
Press the POWER ON/OFF button to switch
on the power, and press the WATER LEVEL
button for 4 seconds until a sound from the
buzzer emits.
To restore, repeat the above or pull out the
plug. When CHILD LOCK is set, CHILD
LOCK on the control panel lights up
indicating E5. If the washer lid is opened
during washing the alarm will buzz for
approximately 5 seconds.
WATER LEVEL
This button allows you to choose the
required water level during the WASH/
RINSE process.
How to set the water level:
Press SELECT until the WASH light flashes,
Press the WATER LEVEL button to choose
the required water level,
Press the SET button to set the wash time.
Press the SELECT button until the RINSE
light flashes,
Press the WATER LEVEL button to choose
the required water level,
Press the SET button to set the RINSE times
and RINSE type.
Press the SELECT button until the SPIN
light flashes,
Press the SET button to set the SPIN time.
Finally press the START/PAUSE button
The machine will start operating according to
the set wash water level and rinse water
level.
MULTIPLE WATER POWER
Press the WATER POWER button to adjust
the water current during washing or rinsing.
Press it once again, the digital display
indicates H0 (standard water power), H1,
H2, H3, H4, (stronger, H4 being the
strongest); L1, L2, L3, L4 (weaker, L4 being
the weakest).
Note: This function cannot be set for the
DELICATE or BLANKET modes.
DELETE END OF BUZZER
Press the POWER ON/OFF button to power
on the machine.
Press and hold down the START/PAUSE
button for 4 seconds until a sound emits
from the buzzer. To restore the End Buzzer
sound repeat the above steps.
DRAIN RESIDUAL WATER
With this function selected, the drain
valve will be opened to drain the residual
water 9 minutes after the program has
finished.
How to drain residual water:
Press POWER ON/OFF to switch the
washer on, hold the PROCESS button for
more than 4 seconds until the buzzer
sounds.