Filter
Top Products
Page 4
UNPACKING
• Remove all packaging and dispose of it in a responsible manner.
• Open the wash-tub lid and remove all the accessories stored in the drum.
• Do not attempt to operate the machine while any of the packaging is still in place.
POSITIONING
• The machine should be installed in a well ventilated
place, away from direct sunlight.
• Hot and cold water taps should be located within 1 metre
of the inlet valves.
• Positioned the machine on a flat and stable uncarpeted
floor capable of supporting the fully loaded washer.
Adjustable levelling feet are located at the front of the ma-
chine and may be turned in or out to achieve stability. An
unstable machine will vibrate and generate excessive noise.
DRAIN HOSE
• Connect the drain hose to the drain outlet at the rear of
the machine and secure it with the hose clamp supplied.
• Hook the outlet end of the drain hose over the lip of a
sink or outlet pipe.
SINK OR LAUNDRY TUB DRAIN
• The top lip of the sink must be at least 860mm (A) above
floor level and not higher than 1300mm.
PIPE DRAIN
• The minimum inside diameter of the pipe drain should be
30mm and the pipe should be able to drain 30 litres per
minute.
• The top lip of the pipe should be at least 860mm (B)
above floor level and not higher than 1300mm.
Installation
Drain hose
Hose clamp
Drain
outlet
A
B