Filter
Top Products
26
* DRY (for DWC-UD121X)
Put the laundry into the Drum and close the Door.
Press the Power button.
• The LED shows only '- --' signal.
Select the 'DRY CONDITION' you want by pressing 'DRY' button.
As this button is pressed, the dry condition is selected by 'Cupboard' → 'Very'
→ 'Time(1:00, 1:30, 2:00)' → OFF → 'Low Temp' → 'Iron' → 'Cupboard'
Press the 'Start/Pause' button.
• The washer will be operated with locking Door.
1
2
3
4
Note
• Do not use the detergent and softener.
• Cold water tap should be opened.
• After finishing this program, is showed on PCB board alternately and the smoothing creases
program is conducted during 30 minute and then power is OFF.
• 'DELICATE' and 'BLANKET' program are not select 'DRY'.
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not
previously
• If the dry performance is poor, change the selecting temperature.
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause'
button.