Filter
Top Products
31
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
Clean the filter when water leaks from the water inlet.
Pull the power plug out
before cleaning it.
Turn off the water
supply to the washer
and separate the inlet
hose.
Pull the inlet filter out. Remove the dirt from
the inlet filter with a
brush.
Open the lower cover(1) by using
a coin. Remove the cap hose(2)
to pull out the hose.
Unplug the cap hose(2), allowing
the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor.
When water does not flow any
more, turn the pump filter(3) open
to the left.
Remove any foreign material
from the pump filter(3).
After cleaning, turn the pump
filter clockwise and insert the cap
hose(2) to the original place.
Close the lower cover.
Cleaning the drain filter
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be caused.
CAUTION : Be careful when draining if the water is hot.
Cleaning the detergent case
After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards
and by pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
• Detergent can also accumulate inside the recess which should be cleaned
occasionally with a brush.
• Once you have finished cleaning, replace the case and run a rinse cycle
without laundry.