Filter
Top Products
13
The Controls - Auto Sensor models (continued)
Sensor Drying
Light
ii) Speedy Iron
Cycle
iii) Timed Drying
iv) Cool Tumble
Phase
This light will glow when Sensor Drying is selected. it will stop glowing
when the load is dry and the programme advances to the Cool Tumble
phase.
This is a short programme of approximately 10 minutes to condition
previously dried clothes (See section “Speedy Iron Programme”).
It consists of a period of heating followed by a short cool tumble
period (as detailed below).
Select high heat for this programme.
It should not be used on damp loads, as it is NOT a drying
programme.
To set the required time, all you have to do is turn the timer control
clockwise until the required time appears in line with the indicator.
Never turn the timer control anti-clockwise.
The chart in the section “Guide to Drying Times” will tell you how much
time you’ll need for various loads.
This programme is particularly useful in cases where a damp load is
required for ironing or LOW heat drying is required and also for small
loads.
About 10 minutes before the programme is completed, the heating
elements are switched off and the programme enters the final ‘Cool
Tumble” phase.
During this phase the fabric is cooled. You should always allow the
dryer to complete this phase.
By opening the door the dryer will stop and you can check the dryness
of the load as often as you wish and if you want to remove (or add)
some items before they are fully dry. (This is particularly useful for a
mixed load where you want to iron some items, but others are to be
fully dried).
After this cycle, the ready signal (Alarm) will sound (if selected) to
remind you that the clothes are ready to take out. To cancel, turn the
timer to ‘0’ or press the option button (to its OUT position).
We recommend that the clothes Are removed immediately this
programme ends to minimise creasing.