Filter
Top Products
10
Timer control
The Cool Tumble
phase
Heat Switch (OUT low heat, IN high heat) Indicator
Turn the timer clockwise from the zero position slightly past the
required time, then back to the required time.
The drying time for both heat settings is controlled by the timer.
Do not rotate the knob beyond 120 minutes (maximum drying time),
or past the zero stop. If you have selected more time than you require
turn the knob anti-clockwise to select the correct time required.
This operation also starts the dryer, provided the door is closed and
the machine is plugged in.The “Guide To Drying Times” section will tell
you how much time you’ll need for various loads.
About 10 minutes before the programme is completed, the heating
elements will be switched off and the programme enters the final ‘Cool
Tumble’ phase. During this phase the fabric is cooled. You should
always allow the dryer to complete this phase.
By opening the door, the dryer will stop and you can check the dryness
of the load a often as you wish and, if you want, remove (or add) some
items before they are fully dry. (This is particularly useful for a mixed
load where you want to iron some items, but others are to be fully
dried).
We recommend that the clothes are removed immediately after this
programme to minimise creasing.
The Controls - Basic Models (not 2-way Tumble models)